CORNING SCF-1728 Podręcznik - Strona 9

Przeglądaj online lub pobierz pdf Podręcznik dla Sprzęt laboratoryjny CORNING SCF-1728. CORNING SCF-1728 14 stron. Heat shrink open ribbon system (hs-ors) canister splice closure

Drukuj stronę

Step 8: Open the plastic clip on the splice plane ("C") and lay

the fibers inside.

Step 9: Carefully close the clip (Figure 18).

Step 10: Lay the fibers all the way down the splice plane on

the side of the organizer while maintaining a full loop

of slack in the storage area.

Step 11: Temporarily secure the fibers at the bottom of the

ORS with another piece of tape (Figure 19).

Step 12: Repeat

Section 10

TPA-6010

11.

Splice

Step 1:

Prepare fibers and splice:

a. To ensure the appropriate length of slack

fibers, cut the fibers extending beyond

the bottom of the closure as shown in

Figure 20.

b. Remove the tape from the fibers.

c. Remove the fibers from the top plastic clips.

d. Lay all fibers on the table.

e. Determine which two ribbon fibers are to

be spliced (one from the left and one from the right).

Route them through the clip again and into the bottom of the closure. Do not close the clip at this

time.

g. Bring the two fibers to the appropriate position in the organizer.

h. Temporarily lay the fibers in the organizer to determine the required length.

Cut both fibers at the same time in the center of the organizer.

for the other side.

TPA-6009

TPA-6011

Standard Recommended Procedure 206-455-AEN | Issue 1 | November 2018 | Page 9 of 14

Figure 18

Figure 19

Figure 20