Makita 6904V Instrukcja obsługi - Strona 2

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Elektronarzędzie Makita 6904V. Makita 6904V 8 stron. Impact driver

Drukuj stronę
ENGLISH (Original instructions)

SPECIFICATIONS

Capacities
No load speed (min
Impacts per minute
Max. fastening torque
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Note: Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
Read instruction manual.
DOUBLE INSULATION
Only for EU countries
Do not dispose of electric equipment
together with household waste material!
In observance of European Directive
2002/96/EC on waste electric and
electronic
implementation in accordance with
national law, electric equipment that
have reached the end of their life must
be collected separately and returned to
an environmentally compatible recycling
facility.
Intended use
The tool is intended for screw driving in wood, metal and
plastic.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
Model
Wood screw / Lag screw
Hex screw
Self-drilling screw
Driving shank
-1
)
Overall length
Net weight
Safety class
equipment
and
END201-5
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Vibration
The vibration total value (tri-axial vector sum) determined
according to EN60745:
its
Work mode : impact tightening of fasteners of the
maximum capacity of the tool
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
ENE033-1
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
ENF002-2
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
2
6904V
180 mm
6 mm
6 mm
6 mm
High: 0 - 2,400
Low: 0 - 2,100
High: 0 - 3,000
Low: 0 - 2,500
196N.m
271 mm
1.8 kg
/II
) : 95 dB(A)
pA
) : 106 dB(A)
WA
Wear ear protection
2
) : 11.0 m/s
h
2
ENG905-1
ENG900-1
ENG901-1