3-form SimpleSpec 400.06 Wovin Wall Instrukcja instalacji - Strona 5

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Wyposażenie wnętrz 3-form SimpleSpec 400.06 Wovin Wall. 3-form SimpleSpec 400.06 Wovin Wall 8 stron.

Drukuj stronę

Ready To Go

SimpleSpec 400.06-Wovin Wall

Installation

Install the Grid

Carefully lift the completed grid and position on the

ceiling. Fasten with screws through the holes in the

joiners. If you have assembled your Wovin Wall in

smaller sections, screw the first section to the ceiling,

then slide the next section onto the joiner tabs and

fasten it in place as shown. Continue until all sections

are fastened.

If you have attached any optional edging you will need

to leave screws out of the joiners around the very edge.

Important: Once the entire grid is assembled within

the frame, carefully push all pieces of the grid out-

wards until all perimeter pieces of the grid are fitting

neatly inside the edging. When you are happy that the

grid has been expanded evenly over the entire area fix

it to the ceiling using the 25 mm chipboard screws in

every plastic joiner.

Install Tiles

Tiles clip into the outermost ridge of each bracket,

as shown below, alternating between horizontal and

vertical alignment.

For more information, please visit 3-form.com or call 800.726.0126

Alternate between horizontal and vertical tiles.

Note: Every second tile around the perimeter will

overhang the edging.

Installation Manual