Panasonic WV-SC385 Instrukcja instalacji - Strona 12
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Kamera Panasonic WV-SC385. Panasonic WV-SC385 36 stron. Ip video cameras
Również dla Panasonic WV-SC385: Specyfikacje (2 strony), Instrukcja instalacji (40 strony), Tabela porównawcza (6 strony), Instrukcja instalacji (40 strony), Instrukcja instalacji (40 strony), Uwaga dotycząca integracji (8 strony)
Drukuj stronę
Precautions for installation
No responsibility will be taken by our company with
respect to consequeces resulting from the use,
damage or both of the camera.
Installing place
Contact your dealer for assistance if you are unsure of an
appropriate place in your particular environment.
• Make sure that the installation area is strong enough
to hold this product, such as a concrete ceiling.
• When the installation area is not strong enough, rein-
force and strengthen it or use an optional mount
bracket
(WV-Q155S,
WV-Q156C or WV-Q105).
• When the product is installed on a wall, use an option-
al wall mount bracket (WV-Q154C).
• When using an outdoor housing to install the product,
use an optional inner cover (WV-Q157).
• The optional mount brackets for WV-NS202A
(WV-Q150C, WV-Q150S, WV-Q151C, WV-Q151S,
WV-Q152C, WV-Q153) cannot be used with this
product.
• When using an optional inner cover WV-Q157, upper
side of images will be hidden (become black) when
the tilt angle of the camera is almost level. (When
"–5°" is selected for "Tilt Angle" on the setup menu,
upper half of images will be hidden.) In this case,
images may also be washed out depending on the
photographic subject when "On" is selected for
"AGC" on the setup menu.
Refer to the Operating Instructions (PDF) for further
information about the setup menu.
Do not place this product in the following places:
• Locations where it may get wet from rain or water
splash
• Locations where a chemical agent is used such as a
swimming pool
• Locations subject to humidity, dust, steam and oil
smoke
• Locations in a specific environment where a solvent or
a flammable atmosphere exists
• Locations where a radiation, an X-ray, a strong radio
wave or a strong magnetic field is generated
• Locations where corrosive gas is produced, locations
where it may be damaged by briny air such as sea-
shores
• Locations where the temperature is not within −10 °C
to +50 °C {14 °F to 122 °F}.
• Locations subject to vibrations (This product is not
designed for on-vehicle use.)
• Locations subject to condensation as the result of
severe changes in temperature (In case of installing
the camera in such locations, the dome cover may
become foggy or condensation may be caused on
the cover.)
12
WV-Q155C,
WV-Q156S,
Procure fixing screws separately.
The screws that secure this product are not supplied.
Prepare them according to the material and strength of
the area where the product is to be installed.
Screw tightening
• The screws and bolts must be tightened with an
appropriate tightening torque according to the materi-
al and strength of the installation area.
• Do not use an impact driver. Use of an impact driver
may damage the screws or cause tightening exces-
sively.
• When a screw is tightened, make the screw at a right
angle to the surface. After tightening the screws or
bolts, perform visual check to ensure tightening is
enough and there is no backlash.
Be sure to remove this product if it is not in use.
Radio disturbance
When this product is used near TV/radio antenna, strong
electric field or magnetic field (near a motor, a transformer
or a power line), images may be distorted and noise
sound may be produced.
PoE (Power over Ethernet)
Use a PoE hub/device that is compliant with IEEE802.3af
standard.
Router
When connecting this product to the Internet, use a
broadband router with the port forwarding function (NAT,
IP masquerade).
Refer to the Operating Instructions (PDF) for further infor-
mation about the port forwarding function.
Time & date setting
It is necessary to set the time & date before putting this
product into operation. Refer to the Operating Instructions
(PDF) on the provided CD-ROM for descriptions of how to
perform the settings.