HP StorageWorks 7110 - Virtual Array Instrukcje aktualizacji - Strona 9

Przeglądaj online lub pobierz pdf Instrukcje aktualizacji dla Przełącznik HP StorageWorks 7110 - Virtual Array. HP StorageWorks 7110 - Virtual Array 12 stron. Private loop (hubs/direct connect)
Również dla HP StorageWorks 7110 - Virtual Array: Korzystanie z instrukcji (34 strony), Instrukcje (4 strony), Podręcznik (4 strony), Podręcznik (4 strony), Instrukcje instalacji (2 strony), Podręcznik (2 strony), Podręcznik (1 strony), Podręcznik (1 strony)

Drukuj stronę

HP StorageWorks 7110 - Virtual Array Instrukcje aktualizacji

Configuring the Upgraded VA 7410/7110 Array

The process of configuring the upgraded VA 7110/7410 is the same process

used for installing a new array. Go to the

Installation Guide

and perform step 3 through step 19. Any differences in the

steps when performing the upgrade are identified below.

Note

The step numbers in this section refer to the corresponding step

numbers in the

Guide.

Step 6. Power-on the array controller enclosure

Because the array does not detect any valid image disks, the array status will

be No Maps. Format the array to create the maps using the following

command:

vfpfmt

Note

Make sure that the disk enclosures are not connected to the

array controller enclosure and operating when performing the

format. This will ensure that the image disks selected for the

array will be in the controller enclosure.

Handling an abterm 70.3.2

If the array detects a valid image disk from the original array, a looping

abterm 70.3.2 will occur due to the incompatible disk image. To clear the

error, perform the following steps:

Power off the array enclosure.

Disconnect all disks from the backplane by sliding them out of the

enclosure one inch.

Power on the array enclosure. The array status should be Not Enough

Disks.

Install the disks back into the controller enclosure.

Format the array to create the image disks:

vfpfmt

The array status should now be Ready and you can proceed with step 7.

HP StorageWorks Virtual Array

HP StorageWorks Virtual Array Installation

Upgrading a VA 7100/7400 to a VA 7410/7110