Olympus U-DA Instrukcja obsługi - Strona 7

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Mikroskop Olympus U-DA. Olympus U-DA 12 stron. Drawing attachment

ASSEMBLY

Fig. 1

...

Fig. 2

Fig. 3

When only the U-DA is mounted on the

microscope frame

1. Using the Allen screwdriver provided with the microscope frame, fully

loosen the clamping screw @ on the microscope frame.

2. Insert the circular dovetail mount at the bottom of the drawing attachment

into the mount on the microscope frame.

3. Rotate the dovetail so the drawing attachment's mirror housing is point-

ing either to the left or right side when looking at the microscope from the

front. (Fig. 1 shows the right-hand installation.)

4. Using the Allen screwdriver, fully tighten the clamping screw @.

# The lens adapter frame (ƒ in Fig. 2) should not be used as it will

cause vignetting of the sketched image.

When the U-DA is mounted above another

intermediate tube

1. Fully loosen the mirror housing clamping knob ² and detach the mirror

housing.

2. Remove the drawing lens | screwed into the adapter tube ³.

3. Unscrew and remove the adapter tube ³.

# The removed adapter tube ³ is not used in this mounting procedure.

4. Screw the lens adapter frame ƒ, provided with the U-DA, into the threaded

ƒ |

hole at the bottom of the mirror housing.

5. Screw the drawing lens | removed in step 2 above, into the lens adapter

frame ƒ.

6. Attach the drawing attachment on the existing intermediate tube.

7. Insert the mirror housing into the relay tube ... and tighten the mirror

housing clamping knob ².

1. Using the Allen screwdriver, fully loosen the clamping screw @ of the

drawing attachment (or another intermediate tube).

2. Insert the circular dovetail mount at the observation tube into the mount

on the drawing attachment.

3. Using the Allen screwdriver, securely tighten the clamping screw @ again.

U-DA

(Fig. 1)

(Fig. 2)

(Fig. 3)