Siemens SIPART PS2 Instrukcja instalacji - Strona 9

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Urządzenia przemysłowe Siemens SIPART PS2. Siemens SIPART PS2 11 stron. Mounting bracket kit
Również dla Siemens SIPART PS2: Instrukcja instalacji (4 strony), Instrukcja obsługi (28 strony), Instrukcja instalacji (4 strony), Instrukcja instalacji sprzętu (30 strony), Opis techniczny (26 strony), Kompaktowa instrukcja obsługi (35 strony), Instrukcja instalacji zestawu (9 strony)

7. If "NOINI" is flashing on display, skip to step 12, otherwise go to step 8.

8. Press and hold [HAND] button to enter configuration mode. When display changes, release

button. See Figure 6.

Slip Clutch

Thumbwheel

9. Press and release [HAND] button until parameter 4 is displayed in lower left corner of display.

10. Press and hold [-] minus button until "no" appears on display.

11. Press and hold [HAND] button to exit configuration mode. When display changes, release button.

12. Using [+] plus and/or [-] minus buttons move valve throughout valve travel. While moving the valve

with the pushbuttons, ensure that:

The feedback linkage moves throughout the entire movement of a full stroke of the valve.

Adjust as needed.

The feedback pin moves freely within the feedback lever for the entire valve travel.

All hardware is tightened securely.

Note: To move quickly in one direction press and hold [+] plus button, then [-] minus button. To

move quickly in the opposite direction reverse button sequence.

13. Use a [+] or [-] button to move the valve to a position away from an end-stop (mid-travel is best).

Verify that the valve remains at that position once buttons are released; if it moves check for air

leaks.

FIGURE 6 PS2 Configuration Mode Display (sample)

Hand

Button

FIGURE 7 Set-up Buttons (PS2 Cover Removed)

(Minus)

+ (Plus)

Button

15900-795

Transmission gear

ratio switch set to 33