Siemens SIPART PS2 Installationsanweisung - Seite 9

Blättern Sie online oder laden Sie pdf Installationsanweisung für Industrielle Ausrüstung Siemens SIPART PS2 herunter. Siemens SIPART PS2 11 Seiten. Mounting bracket kit
Auch für Siemens SIPART PS2: Installationsanweisung (4 seiten), Betriebsanleitung (28 seiten), Installationsanweisung (4 seiten), Hardware-Installationshandbuch (30 seiten), Technische Beschreibung (26 seiten), Kompakt-Bedienungsanleitung (35 seiten), Anleitung zur Installation des Kits (9 seiten)

7. If "NOINI" is flashing on display, skip to step 12, otherwise go to step 8.

8. Press and hold [HAND] button to enter configuration mode. When display changes, release

button. See Figure 6.

Slip Clutch

Thumbwheel

9. Press and release [HAND] button until parameter 4 is displayed in lower left corner of display.

10. Press and hold [-] minus button until "no" appears on display.

11. Press and hold [HAND] button to exit configuration mode. When display changes, release button.

12. Using [+] plus and/or [-] minus buttons move valve throughout valve travel. While moving the valve

with the pushbuttons, ensure that:

The feedback linkage moves throughout the entire movement of a full stroke of the valve.

Adjust as needed.

The feedback pin moves freely within the feedback lever for the entire valve travel.

All hardware is tightened securely.

Note: To move quickly in one direction press and hold [+] plus button, then [-] minus button. To

move quickly in the opposite direction reverse button sequence.

13. Use a [+] or [-] button to move the valve to a position away from an end-stop (mid-travel is best).

Verify that the valve remains at that position once buttons are released; if it moves check for air

leaks.

FIGURE 6 PS2 Configuration Mode Display (sample)

Hand

Button

FIGURE 7 Set-up Buttons (PS2 Cover Removed)

(Minus)

+ (Plus)

Button

15900-795

Transmission gear

ratio switch set to 33