CAB e4 Instrukcja obsługi - Strona 6

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Urządzenie do tworzenia etykiet CAB e4. CAB e4 18 stron. Barcode/label printer the economy class
Również dla CAB e4: Instrukcja obsługi (18 strony)

Drukuj stronę
CAB e4 Instrukcja obsługi
3

Getting Started

6
i
When unpacking the device, check that the delivery is complete and that there has been no transport damage.
Warning!
!
Risk of material damage.
Please ensure the following before starting up the printer:
1.
Set up the printer in a place where there is adequate space available for inserting the transfer ribbon and media.
2.
Ensure that there is adequate ventilation for the device, and keep it out of direct sunlight.
3.
Do not operate the printer in a wet environment or in the vicinity of corrosive chemicals.
4.
Do not exceed the maximum length of cable (according to interface), and ensure that all plugs are easily accessible.

3.1 Connecting the Printer

Warning!
!
Risk of material damage.
The printer must be switched off, power switch in position 0.
Power supply
1.
Plug the power adapter into the power unit.
2.
Plug the output plug of the power adapter into the power input socket on the side of the printer.
3.
Plug the power cable into the power socket.
Interfaces
The printer and PC can be connected by either a serial or parallel cable, a USB cable or an Ethernet link. If you have any
queries, please contact a specialist dealer.
1.
The printer recognizes the selected interface automatically.
2.
The default settings of the interface can be seen on the self-test printout.
3.
The cable confi gurations for the serial (RS 232 C) and parallel (Centronics) interfaces are listed in the appendix.
4.
To avoid transmission problems, ensure that the length of the interface cable does not exceed the specifi cations for the
relevant interface.

3.2 Installing the Printer Driver

The printer driver supports the Windows operating systems 2000/2003/XP.
It is on the supplied CD, or can be downloaded under http://www.cabgmbh.com.
An already installed driver must be uninstalled before a newer driver version can be installed.
i
Switch the printer on before starting the installation.
1.
Select "Start" -> "Settings" -> "Printer and Faxes" -> "Add a printer".
2.
Select "Network Printer" or "Local Printer".
3.
Select the corresponding connection, e.g. LPT1 (parallel port).
4.
Select "Have Disk..." and go to the directory containing the printer driver.
5.
Select the printer model, e.g. cab e4/200, and follow the instructions.
6