CAB e4 Instrukcja obsługi - Strona 7
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Urządzenie do tworzenia etykiet CAB e4. CAB e4 18 stron. Barcode/label printer the economy class
Również dla CAB e4: Instrukcja obsługi (18 strony)
Drukuj stronę
3
Getting Started
3.3 The Label designing Software eLabel
Each e4 printer is supplied with eLabel, a high-performance label designing software application.
i
The printer driver has to be installed before eLabel can be installed.
The software is on the supplied CD ROM. Updates can be downloaded from http://www.cabgmbh.com as and when required.
Start the installation via the user interface on the CD, and follow the instructions of the wizard.
3.4 Loading Labels
1
2
3
1 Media roll guides
2 Media core adapters
1.
Open the cover.
2.
For media rolls with a core diameter between 40 and 75 mm, slide the two core adapters (2) onto the media spindle (3).
3.
Place the media roll (4) on the media spindle (3) with the core adapters.
4.
Slide the media roll guides (1) onto the spindle, with their smooth sides facing the media, until they touch the edges of
the roll.
5.
Insert the spindle with media and guides into the media holder (5), make sure it locks in properly.
6.
Position the media roll in the center of the spindle with the aid of the scale.
7.
Release the printhead module and swing it up.
8.
Feed the media under the axle of the media guides (6) and pull it forwards.
9.
Slide the media guides (6) up to the edges of the media.
10.
Set the position of the media sensor to match the width of the media (see Positioning the Media Sensor).
11.
Close the printhead module by pressing it down until it locks in.
12.
Close the cover, and calibrate the media sensor.
2
4
1
6
6
3 Media spindle
4 Media roll
3
5
5 Media holder
6 Media guides
7