Cisco Firepower 1120 Instrukcja instalacji sprzętu - Strona 26

Przeglądaj online lub pobierz pdf Instrukcja instalacji sprzętu dla Serwer Cisco Firepower 1120. Cisco Firepower 1120 30 stron. Connected grid router
Również dla Cisco Firepower 1120: Instrukcja instalacji (6 strony), Skrócona instrukcja obsługi (10 strony), Podręcznik (6 strony), Instrukcja instalacji sprzętu (42 strony), Podręcznik wdrażania (8 strony), Pierwsze kroki (42 strony), Instrukcja instalacji sprzętu (42 strony)

Connect to the Console Port with Mac OS X

Figure 8: Firepower 1120 and 1140 Console Port Connection

Step 4

Connect the end of the cable with the DB-9 connector (or USB Type A) to the terminal or PC. If your terminal or PC has

a console port that does not accommodate a DB-9 connector, you must provide an appropriate adapter for that port.

The LED for the console port turns green and within a few moments the Found New Hardware Wizard appears.

Step 5

Follow the instructions to complete the driver installation.

Step 6

To communicate with the chassis, start a terminal emulator application. This software should be configured with the

following parameters:

• 9600 baud

• 8 data bits

• no parity

• 1 stop bit

• no flow control

Connect to the Console Port with Mac OS X

Follow these steps to connect a Mac OS X system USB port to the console using the built-in OS X Terminal

utility, or alternatively you can use a separate terminal emulator application.

Step 1

Use the Finder to go to Applications > Utilities > Terminal.

Step 2

Connect the OS X USB port to the chassis.

Step 3

Enter the following commands to find the OS X USB port number:

Cisco Firepower 1100 Series Hardware Installation Guide

USB Mini B console port

USB Type A

USB Mini B to USB Type A console cable

Connect to the Console Port