Direct Supply ATLAS Instrukcja obsługi - Strona 8
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Sprzęt medyczny Direct Supply ATLAS. Direct Supply ATLAS 17 stron. Sit-to-stand lift
Drukuj stronę
Operation
WARNING: Do not attempt to transfer a resident without prior approval from a medical
professional. Do not install, assemble or operate this equipment without fi rst reading and
understanding the instruction manual and observing trained specialists perform a lift.
WARNING: When lifting a resident, the legs of the lift must be in the maximum open position for
stability and safety. If it is necessary to maneuver through a narrow opening, close the legs of the lift
for only the time it takes to move through it, and open again to maximum open position.
CAUTION: More than one assistant is recommended for all resident lift activities; however, one
assistant may be used based on proper evaluation by a medical professional.
Hand Control Buttons
The hand control is used to raise/lower the boom or when lifting a resident.
WARNING: When lifting a resident, DO NOT lock the rear casters. Doing so could cause the lift
to tip and could injure the resident or assistants. The rear casters should be left unlocked during lifts
to allow the resident lift to stabilize itself when the resident is initially lifted from a chair, bed or any
stationary object.
Raising/Lowering the Boom
Press the boom up arrow to raise the boom and the resident.
Press the boom down arrow to lower the boom and the resident.
Raise
Opening/Closing the Legs
Opening and closing the legs requires the use of the spreader bar.
The spreader bar handle (M) is used to open the legs of the base for stability before lifting the
resident. The base legs should be locked in the maximum open position at all times when the
resident is on the lift.
WARNING: For maximum stability, operate this lift with the base legs in the fully open and locked
position when lifting a resident.
To open the base legs, grasp the spreader bar handle (M) in one hand and place the opposite hand on
the steering handle of the mast for balance. Move the handle toward you and away from the locking
plate and then to the far left to open the base legs. To close the legs to a narrow position for transport
or storage, reverse the above procedure.
14
Lower
Activating a Mechanical Emergency Release
CAUTION: Always use extreme caution when activating an emergency release.
Primary Emergency Release
To activate the primary emergency release, insert a pen into the hole labeled "emergency" on the
control box of the lift, and push down on the boom at the same time.
This product's lift actuator is equipped with a mechanical emergency release, which enables
retraction without electrical power. The actuator will only retract when the emergency release lever is
pulled while under load. Locate the emergency release red-colored grip lever.
Secondary Emergency Release
CAUTION: The secondary emergency release is only a backup if the primary emergency release
fails. Use the primary release fi rst. If the primary release fails to function correctly or is out of reach,
the secondary emergency release may be used. To activate the secondary release, pull up on the
red-colored emergency release lever to the MAX position, which is about 11 mm, or when the red-
colored lever can't be pulled up any further, and push down on the boom at the same time. Continue
to lift the red emergency release lever to its maximum position, and push down on the boom until
the boom has been fully lowered.
Primary Emergency Release
Insert a
Pen Here
M
Secondary Emergency
Release Lever
15
1-800-634-7328
DirectSupply.com