Zanussi ZEI6840FBA Podręcznik użytkownika - Strona 10
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Hob Zanussi ZEI6840FBA. Zanussi ZEI6840FBA 20 stron.
Również dla Zanussi ZEI6840FBA: Podręcznik użytkownika (20 strony), Podręcznik użytkownika (20 strony)
Drukuj stronę
Problem
comes on.
comes on
comes on
and a number come on
comes on
If you tried the above solutions and cannot re-
pair the problem, speak to your dealer or the
customer service. Give the data from the rating
plate, three digit letter code for the glass ceram-
ic (it is in the corner of the glass surface) and an
error message that comes on.
Installation
Warning! Refer to the Safety chapters.
Before the installation
Before the installation of the appliance, record
the information below from the rating plate. The
rating plate is on the bottom of the appliance
casing.
• Model ...........................
• PNC .............................
• Serial number ....................
10
Possible cause
The Automatic Switch Off oper-
ates.
The Child Safety Device or the
Lock function operates.
No cookware is on the cooking
zone.
The cookware is incorrect.
The diameter of the bottom of the
cookware is too small for the
cooking zone.
There is an error in the appliance.
There is an error in the appliance,
because a cookware boils dry. The
protection against become too hot
for the cooking zone operates. The
Automatic Switch Off operates.
Make sure, you operated the appliance correct-
ly. If not the servicing by a customer service
technician or dealer will not be free of charge,
also during the warranty period. The instructions
about the customer service and conditions of
guarantee are in the guarantee booklet.
Built-in appliances
• Only use the built-in appliances after you as-
Connection cable
• The appliance is supplied with the connection
Deactivate the appliance and acti-
vate it again.
Refer to the chapter "Daily Use".
Put cookware on the cooking
zone.
Use the correct cookware.
Move cookware to a smaller cook-
ing zone.
Disconnect the appliance from the
electrical supply for some time.
Disconnect the fuse from the elec-
trical system of the house. Con-
nect it again. If
again, speak to the service centre.
Deactivate the appliance. Remove
the hot cookware. After, approxi-
mately 30 seconds activate the
cooking zone again.
go out of the display, residual heat
indicator can stay. Let the cook-
ware become sufficiently cool and
check it with the section Cook-
ware for the induction cooking
zone.
semble the appliance into correct built-in
units and work surfaces that align to the
standards.
cable.
Remedy
comes on
should
www.zanussi.com