Clarke EZ-8 Instrukcja obsługi - Strona 6
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Maszyna podłogowa Clarke EZ-8. Clarke EZ-8 20 stron. Drum sander
Również dla Clarke EZ-8: Obsługa i bezpieczeństwo (2 strony)
Drukuj stronę
- 1. Table of Contents
- 2. Operator Safety Instructions
- 3. Introduction and Machine Specifications
- 4. How to Transport the Machine
- 5. Machine Set-Up
- 6. How to Operate the Machine
- 7. Sanding Cuts and Sandpaper
- 8. Sander Adjustment Procedures
- 9. Routine Maintenance
- 10. Troubleshooting
- 11. Section II Parts and Service Manual
- 12. Assembly Drawing #1 11/01
- 13. Assembly Parts List #1
- 14. Assembly Drawing #2 10/01
- 15. Assembly Parts List #2 7/03
- 16. Wiring Diagram 9/92
How to Transport the Machine
Transporting the Machine With Limited
Cargo Area:
To transport the machine, follow this procedure:
1. Lower sanding drum with control lever. See figure
#1.
2. Slide collar beyond overlap of control link; remove
pin from notch. See figure #2.
3. Twist and remove handle pigtail from motor cord.
See figure #3.
4. Release handle latches and remove handle from
chassis. See figure # 2.
5. Remove dust pipe from chassis.
6. Lift chassis with transport handles and place in
cargo area. See figure # 4.
WARNING: Machine is heavy (95 lbs.). To
avoid injury or damage grasp
transport handles firmly; use
proper lifting technique.
7. Secure chassis to prevent movement in cargo area.
Place handle and dust pipe in cargo area.
Figure # 4
Page 6
Figure # 1
Figure # 2
Figure # 3
American Sanders EZ - 8 Sander Operator's Manual
Clarke
®