Clarke EZ-8 Instrukcja obsługi - Strona 8

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Maszyna podłogowa Clarke EZ-8. Clarke EZ-8 20 stron. Drum sander
Również dla Clarke EZ-8: Obsługa i bezpieczeństwo (2 strony)

Drukuj stronę

How to Operate the Machine (cont.)

CAUTION: To prevent damage to the surface,

make sure the machine is always

moving when the sanding drum is

in contact with the floor.

2. Work right to left. For each forward pass, move

the machine 4" over the pass you have just

finished. Retrace your reverse path without

overlapping. See figure # 9

3. Feather-cut in by easing the sanding drum down

onto the surface with the control lever while the

sander is in motion.

4. When sanding drum is fully engaged with the

surface, release control lever and adjust your

pace for adequate stock removal. Keep sander

in motion while the sanding drum is engaged with

the surface or dwell marks will occur.

5. Move the machine in the direction of the grain in

the wood whenever possible. Sand the surface

at a constant pace.

6. Gradually feather-cut out at the termination point

(the end of your pass) by easing the sanding

drum up with the control lever. Stagger the

termination points for a better blend when

edging. See figure # 9.

7. When replacing abrasive, emptying contents of

dust bag, or when sanding operation is com -

pleted, press selector switch to off (O) position.

Disconnect the machine from the power supply.

8. Empty dust bag whenever it is 1/3 full. Never

leave a dust bag unattended with sanding dust in

it. Sanding dust can spontaneously ignite and

cause a fire or explosion. Empty dust into a

metal container clear of any combustible mate-

rial.

Page 8

Figure 9

American Sanders EZ - 8 Sander Operator's Manual

Clarke