3DUpFitters Ender 3 V2/CR-6 Enclosure Kit Instrukcja instalacji - Strona 9
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Drukarki 3D 3DUpFitters Ender 3 V2/CR-6 Enclosure Kit. 3DUpFitters Ender 3 V2/CR-6 Enclosure Kit 16 stron.
Również dla 3DUpFitters Ender 3 V2/CR-6 Enclosure Kit: Instrukcja instalacji (15 strony)
Drukuj stronęConfirm the direction of the fan by plugging it into
a USB power supply before attaching the filter.
The round label should be on the outside
The fan should be attached on the outside of
the enclosure.
The fan should be oriented to pull air OUT of
the enclosure.
Use the long screws included in the fan packet to
attach the fan. The length of the screws may
change depending on the depth of this particular
shipment of fans.
Copyright 2021 3DUpfitters
9