Asko TD70.1 SPO Instrukcja instalacji - Strona 2

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Suszarka Asko TD70.1 SPO. Asko TD70.1 SPO 12 stron. Domestic vented tumble dryer

Drukuj stronę

Installation instructions

WARNING!

WARNING - Risk of ﬁ re.

Install the clothes dryer according to the

manufacturer's instructions and local codes.

Do not install a clothes dryer with ﬂ exible

plastic venting materials. If ﬂ exible metal (foil

type) duct is installed, it must be of a speciﬁ c

type identiﬁ ed by the applience manufacturer

that is UL approved for use with clothes

dryers. Flexible venting materials are known to

collapse, be easily crushed, and trap lint. These

conditions will obstruct clothes dryer airﬂ ow and

increase the risk of ﬁ re.

To reduce the risk of of severe injury or death,

follow all installation instructions.

SAVE THESE INSTRUCTIONS FOR FUTURE

REFERENCE.

Positioning the tumble dryer

The tumble dryer can be freestanding or

stacked. Remember that the tumble dryer

produces heat and should therefore not be

located in a room that is too small. If the room

is very small, drying will take longer due to the

limited quantity of air.

NOTE!

• Do not install the machine in a room where

there is a risk of frost occurring.

At temperatures around freezing point the

machine may not be able to operate properly.

• The room in which the appliance is installed

should be adequately ventilated, with

temperature between 15°C and 25°C.

WARNING!

• Clothes dryer installation must be performed

by a qualiﬁ ed installer.

• For proper ventilation, the machine should

not be installed behind a door.

• The tumble dryer's toe kick ventilation must

not be blocked by a rug or the like.

NOTE!

If the unit must be installed behind a door, the

door should be louvered. (please see door

ventilation requirements in the Built-in chapter).

To improve ventilation, the door where the

tumble dryer is located should be left open

when the dryer is in use.

Freestanding

The tumble dryer can be positioned beside the

washing machine.

Stacking

The tumble dryer can be placed on top of an

ASKO washing machine. Use the two foot cups

found in the document bag included with the

machine and the two tip guards attached to the

bottom of the back of the machine.

How to assemble the stacking kit:

1. Remove the two tip guards from the back of

the tumble dryer. Replace the screws that

held the tip guards in place.

2. Remove the two screws indicated on the

back of the washing machine.

Customer Care Center

1-800-898-1879