AmeriGlide RUBEX Manual de instalação - Página 8

Procurar online ou descarregar pdf Manual de instalação para Sistemas de elevação AmeriGlide RUBEX. AmeriGlide RUBEX 16 páginas.
Também para AmeriGlide RUBEX: Manual do Proprietário (8 páginas)

Imprimir página

to the steps using provided wood screws.

Step 11: Track is designed to lay directly on the

step noses, or it can be supported

completely by the track brackets.

Step 12: Pull a piece of string taut from the

top of the track to the bottom. Mark any places

where the string is not parallel with the track.

Check the results by using the string again. Track

and string should now be parallel.

The wall-side of the track may be pulled down

further than the stair side of the track on

steps with thick carpeting/pad. Final track

adjustment should occur after the unit is

installed.

The track should still move vertically in the

bracket slots for final adjustment.

Rubex Stair Lift Install Manual | www.Ameriglide.com | 866-378-6648

8 //

Step 7: Slide the track and brackets toward the

wall or molding. The edge of the track needs to

be positioned 3

" from the wall. If there is an

obstruction on the wall; ie: handrail, window sill,

etc; the track will need to be positioned 3

out further than the obstruction. Temporarily set

something (like a book) under the bottom of the

track to raise it

" –

This will prevent the track from hitting the floor

later when the track brackets are tightened.

Step 8: With bracket resting on step, position track

bolt in upper half of track bracket slot.

Step 9: Starting with the bottom step, screw the

bracket half-way down – remove placed obstruction

used to raise track – and finish by securely attaching

bracket to the step.

Step 10: Securely tighten remaining track brackets

" off the bottom landing.

Ilus1. - Track shown

with sagging area

due to "short" step

11819 P/N: 16169 Rev D