AmeriGlide RUBEX Manual de instalação - Página 9
Procurar online ou descarregar pdf Manual de instalação para Sistemas de elevação AmeriGlide RUBEX. AmeriGlide RUBEX 16 páginas.
Também para AmeriGlide RUBEX: Manual do Proprietário (8 páginas)
Imprimir página11819 P/N: 16169 Rev D
ROUTING THE LOWER CALL CONTROL WIRE
Step 1: On the wall-side of the track, attach call
control bracket to the second nut up from the
bottom just above the bottom track bracket.
Step 2: Route the wire through the top track
channel on the wallside of the track.
Step 3: At the top of the middle section of track,
tuck the wire underneath the track out of the way.
Step 4: You will finish routing the call control wire
after the top track section is in place.
INSTALLING THE UNIT
Caution:
Assistance may be needed for this part of the installation due to
unit's and upper track section's weight.
Step 1: Open unit box by cutting down the sides of the box. Fold the sides
of the box down and slide the unit and top track to the edge of the steps.
Step 2: Remove cardboard packing from back of
footrest.
Step 3: Remove the shipping brace from the
upper section of track and set aside.
Make sure the packing bracket is removed
and discarded before attempting to
operate the lift.
Rubex Stair Lift Install Manual | www.Ameriglide.com | 866-378-6648
Rave Stair Lift Manual | www.Ameriglide.com | 866-378-6648
Completely remove
the packing bracket.
9 //
16