CANTO 2000 Manual de instruções - Página 6

Procurar online ou descarregar pdf Manual de instruções para Destaque CANTO 2000. CANTO 2000 11 páginas. Follow spotlight metal halide and tungsten-halogen

Imprimir página

4. MOUNTING THE IRIS

The iris supplied with the followspot uses 20 leaves to size the beam from a maximum aperture of 2.68"

(68mm) to a minimum of 0.20" (5mm). A blackout iris is available on special order. The iris is preassembled

in Strong Entertainment Lighting units, and replacements are installed as follows:

a. Using a phillips screwdriver, remove the two cross-head screws from the sides of the iris bracket

located in the gap between the lamphouse and optical system. Lift the old iris out of the bracket.

b. Slide the new iris down into the bracket, flat surface toward the lamphouse.

c. Replace the screws.

Important Notice: while the lamp is on. . .

Do not leave the iris closed for longer than:

• 10 minutes on Canto 575, Canto 700, Canto 1000 and Canto 1200

• 2 minutes on Canto 2000

Use the douser (front lever) to cut off the light should you require to have the lamp "on" with no beam

projecting to the stage.

FAILURE TO COMPLY WITH ABOVE NOTICE MAY CAUSE THE IRIS AND THE FOLLOWSPOT

TO SUFFER MAJOR HEAT DAMAGES AND WILL INVALIDATE THE PRODUCT WARRANTY

5. SHUTTER BLADES

Shutter blades are not supplied with the unit but are available as separate accessory. They are sold as

single items and relevant part number is 80852039.

6. ADJUSTING THE YOKE

This followspot is provided with a yoke balancing adjustment. The balancing point is factory-set for

standard usage of the product; however, should you need to adjust the balancing, proceed as follows:

a. The followspot must be tripod mounted.

b. Using a phillips screwdriver, loosen the (2) 5mm screws on each side of the yoke.

c. Gently slide the followspot backwards or forwards to the required position.

d. Make sure the yoke is correctly aligned horizontally.

e. Tighten the (4) 5mm screws.

7. WIRING

Before being connected to the AC source, this unit needs to be wired with a suitable plug. Make sure the

plug you are using meets the lamp's current load. Ensure the plug conforms to the relevant UL electrical

standards and local codes.

To insure correct wiring, refer a licensed electrician to the instructions given on the label attached to the

loose end of the power cable.