Amsino PUGGLE Configuração rápida

Procurar online ou descarregar pdf Configuração rápida para Bomba de água Amsino PUGGLE. Amsino PUGGLE 2 páginas. Enteral feeding pump
Também para Amsino PUGGLE: Manual de referência rápida (12 páginas)

Imprimir página

The PUGGLE® Enteral Feeding Pump

the AC adapter provided with the pump.

The PUGGLE Enteral Feeding Pump may be fixed onto a vertical pole using the pole clamp provided with the

pump.

Important:

For the PUGGLE Enteral Feeding Pump and its alarms to operate properly, use only PUGGLE

Enteral Feeding Sets with this device. The pump is not compatible with other pump sets.

Feeding Bag Placement

Place feeding bag above the pump.

For better accuracy, the initial fluid level shall be at

15.2 cm (6.0 inches) higher than the pump and the

pump shall be placed higher than the injection site.

Do NOT use homemade or non-prescribed formula.

The setting range of operating head height is

0~50 cm (0~19.68 inches) which has been

verified as worst-case condition.

1. Open pump cover.

2. Place the silicone loop around the rotor and make sure the cassette is

in the right direction.

3. Push the cassette in the middle of the pins with your thumb and make

sure the cassette is positioned correctly between the two black pins.

Guide both tubes down, in line with their respective slots.

4. Close the pump cover, then place the adapter into the designated slot.

Remove the protective cap from the distal connector (end of down-

stream tube that goes on the patient's feeding tube).

Launch automatic priming.

Connect the tubing to the patient enteral feeding tube and program

the pump.

Scan the QR code to view the

PUGGLE Enteral Feeding Pump

Instructional Video

is delivered with an uncharged battery. Before use, charge by using

Loading Disposable Set

Quick Set Up

Tubing Diagram

Silicone loop

Cassette

Upstream tube

Downstream tube

Adapter