Draper Patriot Motorized Flag 500101 Manual de instruções - Página 4
Procurar online ou descarregar pdf Manual de instruções para Mobiliário de interior Draper Patriot Motorized Flag 500101. Draper Patriot Motorized Flag 500101 8 páginas.
Imprimir página
Patriot Motorized Flag
Section 2 - Bottom Patriot Panel Installation/Removal
Bottom Access Panel Door
CAUTION: Beware of pinch points at ends of closure
CAUTION: The following requires two people to perform safely.
1. Press up on access panel and pull toward the front of the flag
housing to disengage hinges and remove access panel.
Access
Remove Screws
Panel Door:
Pivot on Hinges.
from both ends
of Housing.
Section 3 - Operation
CAUTION: When operating for the first time, cycle unit down and up several times to confirm satisfactory operation. Be prepared to cut POWER if necessary.
•
KEY OPERATED SWITCH
(standard)
•
Key-operated power supply switch controls power to flag and switches. When "off", switches will not operate flag. Key may be removed from switch in either
"on" or "off" position.
•
3-position key switch permits the flag to be operated directly by key. Requires flag operator to have a key.
Bottom flange of
Access housing
Figure 3
Case as seen from below
Figure 4
Removing Access Panel
- Two key-operated switches optionally available with this unit:
Bottom access panel secures to the Motorized Flag
housing with two screws
(one on each end)
closed position by engagement brackets with ball detents
that snap into case support brackets
2. To Remove/Install support brackets:
page 4 of 8
, and held in the
.
(Fig. 3)
Access Panel
Support Bracket
Attaching Brackets:
Insert pin in top
1
slot and push up.
Rotate bracket
2
clockwise to lock
bracket in place.
Engagement Bracket
With Ball Detent:
will snap into Access
Panel Support Bracket.