Dremel DigiLab 3D45 Manual - Página 4

Procurar online ou descarregar pdf Manual para Impressoras 3D Dremel DigiLab 3D45. Dremel DigiLab 3D45 4 páginas. Print removal
Também para Dremel DigiLab 3D45: Manual de início rápido (2 páginas), Instruções de serviço (4 páginas), Manual de instruções (2 páginas), Manual de serviço (4 páginas), Manual de Calibração (2 páginas), Manual de início rápido (2 páginas)

3. Removing the Extruder Motor.

a. Disconnect the white extruder terminal block from the

extruder connector as shown in the picture below.

Ensure to grab the block and avoid pinching the wires.

b. Unscrew the two motor screws below using the Torx

screwdriver, as shown in the picture below. Please

ensure that the screws once fully unscrewed, should

still be left inserted in the extruder chassis hole.

c. Pull the extruder motor assembly away from the printer

(vertically) as shown in the picture below.

2610038113

Congratulations!

You are now ready to build. Build On.

4. Cleaning the stepper gear. There might be filament residue

in your stepper motor gear, use your brush to clean the

gear of the stepper motor.

5. Replace Extruder Motor.

a. Place the extruder motor on the chassis. Extruder motor

screw holes should line up with holes in the chassis.

b. Tighten the two hex screws with 2.5mm Hex wrench.

Refer picture under Step 3b.

c. Plug in the white terminal block on the extruder connec-

tor as shown in picture under Step 3a (encircled).

6. Replace Top Cover.

a. Attach the filament runout switch wires of the cover to

the extruder circuit board. Refer picture under Step 2d.

b. Place the new top cover over the extruder.

c. Replace the two 2mm screws onto the cover. Refer

picture under Step 2c.

7. Test the Machine.

a. Plug in and turn on the 3D45.

b. Navigate to "Filament" and follow the on screen instruc-

tions to load filament.

c. Build a file on the machine to ensure the 3D45 printer

is working correctly.

05/2018