Bosch 2 Manual de Instruções - Página 5

Imprimir página

Individual settings

Function buttons

The spin speed and temperature can be changed before and during the selected

programme. The effects depend on the programme progress.

Temp.°C

You can change the displayed washing temperature. The maximum washing temperature

that can be selected depends on the programme that has been set.

rpm

(spin speed //

(Rinse stop = no final spin))

You can change the spin speed shown or select

laundry remains in the water after the last rinse, display panel - - - -). The maximum selectable

spin speed depends on the model and on which programme is currently selected.

Ready in

When you select the programme, the relevant programme duration is displayed. You can

delay the start of the programme before it begins. The "Finished in" time can be set in

increments of one hour up to a maximum of 24 hours. Press the Ready in

repeatedly until the required number of hours is displayed (h = hour).

Press Start/Pause

Option buttons

Programme overview, page 7

SpeedPerfect

For washing in a shorter time with a washing result comparable to that

of the standard programme. Maximum load

Programme overview, page 7.

EcoPerfect

For saving energy with a comparable washing effect to the standard

programme.

Rinse Plus

Additional rinse cycle. For areas with very soft water or for further

enhancing the spin result.

Childproof lock

You can lock the washing machine to prevent the functions you have

on the display panel

set from being changed inadvertently.

ON/OFF: after the start/end of the programme, press and hold the

Start/Pause button for approx. 5 seconds.

Note: The childproof lock can remain activated until you wish to start

the next programme, even after switching off the machine.

Then you can deactivate the childproof lock before starting the

programme and activate it again as necessary once the programme

has started.

Start / Pause

To start, pause and continue the programme and to activate/deactivate the childproof lock.

(Rinse stop (Spülstop) = no final spin,

button

Individual settings

Signal

1. Activate the setting mode for the signal volume

To activate the

setting mode

set to

2. a) Set the volume for button signals( depending on model)

rpm

press repeatedly until

the desired volume is

reached

2. b) Set the volume for information signals

turn one

position to

the right

Information on the display panel

Turn the (cold water) tap on fully;

supply hose kinked/trapped;

water pressure too low; service, clean the filter

Detergent solution pump blocked; service, clean the detergent solution pump

page 10.

Drainage hose/waste pipe blocked; service, clean the drainage hose at the siphon

page 10.

Water in the base tub, appliance leaking. Turn off the tap. Call the after-sales service.

Childproof lock active; Deactivating

Switch off the appliance, wait for 5 seconds and switch it back on again. If the display

Other

displays

appears again, call the after-sales service.

rpm

press and

turn one

press and hold for a

hold

position to

further 5 secs until the

the right

display elements light up;

setting mode is activated

set to

to exit the setting

mode for the signal

volume

rpm

press repeatedly until the

set to

to exit the

desired volume is

setting mode for the

reached

signal volume

depending on model

page 10,

page 5.