Aus Electronics Direct HDEX0021M1 Manual do utilizador - Página 5

Procurar online ou descarregar pdf Manual do utilizador para Extensor Aus Electronics Direct HDEX0021M1. Aus Electronics Direct HDEX0021M1 8 páginas. 200m hdmi wireless extender

Imprimir página

Panel key operation instructions:

Select transmission rate: When the rate switch is selected at "HIGH," the

product works in high rate mode, the RX has the best picture quality. If the

rate switch is selected at "LOW", the product works in low rate mode, the RX

has the best working distance at the moment.

Change Wireless channel: Press the "CHANNEL" key on the front panel of

TX to cyclic switch the multiple wireless channels. If the product works

unsteadily or pictures not fluent, You can try a different working channel.

3. Restore Factory Setting: To press the button for lasting three seconds, then

the HDMI Status Led Light will flash for three times and restart, it shows that

Restore Factory Set is successful.

The Factory Reset Button is located at the bottom of the Hole of the IR IN/OUT.

It is able to work under power on status. To use one long and narrow insulated

stick (like toothpick) to insert the hole end to press the button.

Note: You must to restore factory set at transmitter and all receivers before

they can be reused.

Web settings:

To prevent the interference caused by the same frequency device, the Wireless

HDMI Extender support to set up the , transmit channel andSSID by the WEB.

For safety, the user should change the SSDI and the password at the first log in.

Please follow the below steps:

1. Connect 5V power supplies to the transmitter and all receivers, and let

them be connected.

2. Turn on the WLAN of the mobile phone / PC，search and connect SSID：

Multi_HDMI_Wireless, Enter the default password: 00000000.

3. Modify the IP address type of the mobile phone / PC to Auto. When you

select static type, you must be set the IP in 192.168.1. xxx address segment

range, e.g. 192.168.1.100.

4. Open the browser and scan the QR code or enter "192.168.1.10" in the

address bar to enter the configuration page.. As shown below: