Dynaphos CraftLine GS-300 Manual de instruções - Página 5

Procurar online ou descarregar pdf Manual de instruções para Flash da câmara Dynaphos CraftLine GS-300. Dynaphos CraftLine GS-300 8 páginas. Studio flash

Imprimir página
Flash Control
Craftline GS studio flash has power range from 1/1 to 1/32 (6 EV), which can be adjusted
through the flash output controller
with numbers from 8.0 to 5.0. If you reduce the power output with one more increment under 5.0, the
digial display will show "OF" symbol and the flash will stay turn on, but it won't be able to fire a flash.
When reducing the flash output, the Auto Dump function will turn on and it will discharge the capacitors
to the set lower power. Depending on the size of the adjustment this proces will take between 2 and 45
sec. When reducing the power output with more than 1 EV is recommended to discharge the capacitors
manually in order not to wait the whole process.
Craftline GS studio flash has fully manual control of the modeling light. To turn on or off the
modeling lamp, press the button
controller
4.
When the flash is on and idle for more than two hours , the modeling lamp will automatically
turn off. Restart the flash to turn it back on.
Overload and overheat protection
During continious work with the flash (large number of flashes for a short term), an overheating
may occur. To protect the flash, don't make more than 20 flashes in a row with higher power output (7.0 -
8.0). After every 20 contiguous flashes leave the flash to cool down for at least 3 min.
When working with light control accessories such as spots, which are preventing the cooling, you
have to limit the modeling light use and the flash shouldn't be used too intense.
If the flash is used carelessly about its temperature this may cause failure, in which case Dynaphos
Ltd. reserves the right to refuse warranty repair.
4
3.
in 30 steps and it's shown on the digital display
8.
You can steplessly control it trough to the modeling light output
Guide
(check pic. 2)
2.