Dynaphos CraftLine GS-300 Manual de instruções - Página 6

Procurar online ou descarregar pdf Manual de instruções para Flash da câmara Dynaphos CraftLine GS-300. Dynaphos CraftLine GS-300 8 páginas. Studio flash

Imprimir página

Sync triggering

Plug the sync cable or connect the flash trigger receiver in the usb port jack

Connect the sunchro cable or the receiver with the camera and set the camera on the max. shutter speed.

(check the camera manual instructions) When pressing the camera shutter release, simultaneously the

flash will fire an impulse.

If you use more than one flash, the others will be activeted through their photo cells. Use the

button

to turn on or off the photo cell, as well as to set a mode for triggering with 1st or 2nd flash. (the

last one is used when activating through manual flash with Pre Flash function). When the button

tor flashes blue, 1st flash trigger mode is set on, when it flashes red the 2nd flash mode is set on. When the

photo cell is turn off, the indicator won't flash. In some cases it is possible the intense of the master flash to

be insufficient to trigger the rest of the flashes through their photo cells. In this case use additional receiv-

ers for each flash.

You can also trigger the flash by the "Test" button

Slave mode

Through the optional FT-16 wireless power control and trigger, you can remotely trigger and con-

trol off the flash power, pilot light and the photo cell of 16 separate flashes (groups) Expert QS. For this

purpose you will need a FT-16 power control and trigger kit

designed for work with studio flashes Expert QS, Speedster QT, Craftline GS, Starter DE, Witstro and XEner-

gizer.

To trigger and power control a flash with FT-16:

- open the battery compartment of the sender and place 2 alkaline batteries 1.5V AA as following the right

polarity.

(product № 010288)

Guide

(check page 2)

indica-

The device is specially