highwood Pottsville Manual de montagem - Página 2

Procurar online ou descarregar pdf Manual de montagem para Equipamento para relva e jardim highwood Pottsville. highwood Pottsville 4 páginas.

Before you start

IMPORTANT Check for underground services with your local authorities BEFORE installation of this product.

They will typically mark out underground cables/gas etc at no charge.

Step 1

Set the fence in the desired location and carefully measure and

mark the ground where the center of each post will fall assuring that

each rail will set at a 45 degree angle as shown below.

45˚

Step 2

Install metal ground stake for center post

Measure and mark the half way point on Metal ground stake (E)

as shown in Figure 1 below. Place Stake (E) in desired location for

Center Post (B) and carefully use a hammer to drive it into ground.

Use level to make sure the stake is straight and plumb. Adjust as

needed and finish driving it into the ground using a small block of

wood on top of stake as shown in Figure 2 below. Install no deeper

than the half-way point.

Fig. #1

45˚

Fig. #2

Step 3

Set ground stake tabs into place

Use a flat head screwdriver and/or a set of pliers to bend the

locking tabs on Metal ground stake (E) into appropriately a

45 degree angle as shown in Figure 3 below.

Fig. #3

45˚