Brother Stampcreator PRO SC2000USB Referência rápida - Página 31
Procurar online ou descarregar pdf Referência rápida para Fabricante de etiquetas Brother Stampcreator PRO SC2000USB. Brother Stampcreator PRO SC2000USB 36 páginas.
Imprimir página
Cleaning the print head
a Flip off the SC-2000USB's power switch.
b Open the ink ribbon compartment cover, then pull back the print head
cover.
c Use the enclosed print head cleaning pen to gently wipe back and
forth along the print head.
☞ Be careful not to touch the print head.
Keep the cap on the print head cleaning pen when it is not being
used.
d Release the print head cover and close the ink ribbon compartment
cover.
e Try printing again.
f If the printed characters are still blurred, repeat steps a through e.
Replacing the xenon lamp unit
The xenon lamp unit has a life span of approximately 2000 flashes. When the message "REPLACE Xe UNIT" appears on
the display, the xenon lamp unit must be replaced.
a Press the Mode button on the SC-2000USB until "RESET COUNTER" appears on its display, then press the Set button.
b Slide the xenon lamp unit release lever up and pull out the xenon lamp
unit.
c Fully insert the new xenon lamp unit until it locks into place. Check
that "N = 0" appears on the display of the SC-2000USB.
d Press the Set button on the SC-2000USB.
28
Print head cover
Print head
Xenon lamp unit
release lever
Xenon lamp unit
compartment