Brother Stampcreator PRO SC2000USB Hızlı Referans - Sayfa 31

Etiket makinesi Brother Stampcreator PRO SC2000USB için çevrimiçi göz atın veya pdf Hızlı Referans indirin. Brother Stampcreator PRO SC2000USB 36 sayfaları.

Brother Stampcreator PRO SC2000USB Hızlı Referans

Cleaning the print head

a Flip off the SC-2000USB's power switch.
b Open the ink ribbon compartment cover, then pull back the print head
cover.
c Use the enclosed print head cleaning pen to gently wipe back and
forth along the print head.
☞ Be careful not to touch the print head.
Keep the cap on the print head cleaning pen when it is not being
used.
d Release the print head cover and close the ink ribbon compartment
cover.
e Try printing again.
f If the printed characters are still blurred, repeat steps a through e.

Replacing the xenon lamp unit

The xenon lamp unit has a life span of approximately 2000 flashes. When the message "REPLACE Xe UNIT" appears on
the display, the xenon lamp unit must be replaced.
a Press the Mode button on the SC-2000USB until "RESET COUNTER" appears on its display, then press the Set button.
b Slide the xenon lamp unit release lever up and pull out the xenon lamp
unit.
c Fully insert the new xenon lamp unit until it locks into place. Check
that "N = 0" appears on the display of the SC-2000USB.
d Press the Set button on the SC-2000USB.
28
Print head cover
Print head
Xenon lamp unit
release lever
Xenon lamp unit
compartment