Brother Stampcreator PRO SC2000USB 빠른 참조 - 페이지 31

{카테고리_이름} Brother Stampcreator PRO SC2000USB에 대한 빠른 참조을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother Stampcreator PRO SC2000USB 36 페이지.

Cleaning the print head

a Flip off the SC-2000USB's power switch.

b Open the ink ribbon compartment cover, then pull back the print head

cover.

c Use the enclosed print head cleaning pen to gently wipe back and

forth along the print head.

☞ Be careful not to touch the print head.

Keep the cap on the print head cleaning pen when it is not being

used.

d Release the print head cover and close the ink ribbon compartment

cover.

e Try printing again.

f If the printed characters are still blurred, repeat steps a through e.

The xenon lamp unit has a life span of approximately 2000 flashes. When the message "REPLACE Xe UNIT" appears on

the display, the xenon lamp unit must be replaced.

a Press the Mode button on the SC-2000USB until "RESET COUNTER" appears on its display, then press the Set button.

b Slide the xenon lamp unit release lever up and pull out the xenon lamp

unit.

c Fully insert the new xenon lamp unit until it locks into place. Check

that "N = 0" appears on the display of the SC-2000USB.

d Press the Set button on the SC-2000USB.

Print head cover

Print head

Xenon lamp unit

release lever

Xenon lamp unit

compartment