BilJax Pro-Jax Utility Scaffold Instruções de montagem - Página 3
Procurar online ou descarregar pdf Instruções de montagem para Equipamento industrial BilJax Pro-Jax Utility Scaffold. BilJax Pro-Jax Utility Scaffold 4 páginas. Building a one frame high scaffold
Imprimir página
STACKING PRO-JAX
According to OSHA, all scaffolds must be restrained from tipping. This can be accomplished in one
of three ways:
1. For free standing scaffolds, the maximum platform height must not exceed 3 times* the narrowest
base dimension.
2. Guying the scaffold.
3. Tying the scaffold to a wall or other solid structure.
*Federal OSHA allows a maximum platform height of 4 times the narrowest base dimension. However, Bil-Jax recommends
that the maximum height be limited to 3 times the narrowest base dimension on all Pro-Jax utility scaffolds.
When additional platform height is required on a free standing scaffold, outriggers may be used to
extend the base dimensions. Bil-Jax has different size outriggers available for use with Pro-Jax
units. 18" wide outriggers are for use with two-frame high scaffolds and 24" wide outriggers are for
use with three-frame high scaffolds.
Whenever Pro-Jax units are stacked, outriggers are required! Do not use a
Pro-Jax utility scaffold over 1 frame high without outriggers. Failure to use
outriggers will make scaffold more likely to tip over causing serious injury
or death!!
BUILDING A TWO FRAME HIGH SCAFFOLD
If the platform height needed is between 6' and 11' 6", it will be necessary to install 18" wide
outriggers and a second scaffold level prior to use.
—
STEP ONE
Erect the base
unit (one frame high scaffold) by
following the previous instruction.
—
STEP THREE
Tighten clamp securely. Clamp must be flush against scaffold leg and casters must be
in contact with the surface.
Top View
Outrigger
Frame
—
STEP FOUR
Add
second scaffold level by
stacking end frame over
insert pins in top of base
unit end frames. Secure
in place with snap pins.
®
UNITS FOR ADDITIONAL HEIGHT
WARNING
STEP TWO
four (4) outriggers and secure with snap pin
provided with each caster. Set caster brake.
Clamp outrigger to end frame at a 90
Tighten
Securely
Outrigger
—
Install casters into all
°
angle to the side brace.
Side View
Frame
Leg
STEP FIVE
side braces (minimum two),
platform, and guard railing at
desired height per the previous
instructions (Building a One
Frame High Scaffold).
- Page 6 -
—
Install