Panasonic WVNW964 - NETWORK CAMERA Manual de instalação - Página 24

Procurar online ou descarregar pdf Manual de instalação para Câmara de vídeo Panasonic WVNW964 - NETWORK CAMERA. Panasonic WVNW964 - NETWORK CAMERA 32 páginas. Ip video cameras
Também para Panasonic WVNW964 - NETWORK CAMERA: Manual de Instruções (21 páginas), Manual de serviço (28 páginas), Brochura (2 páginas), Referência (2 páginas), Referência (2 páginas), Especificações (2 páginas), Nota de integração (8 páginas)

Imprimir página

Panasonic WVNW964 - NETWORK CAMERA Manual de instalação

Initialize the camera

Use the DIP switch to initialize the camera.

Important:

The settings including the network settings will be initialized. Note that the preset position settings will not be ini-

tialized.

Step 1

Detach the housing attachment base, and then flip the

protection sheet on the upper portion of the sun shield.

• Refer to the operating instructions of the housing

attachment base for how to detach the sun shield.

Upper portion of the sun shield

DIP switch

Step 2

Set DIP switch 1 to "ON".

• The default positions of each DIP switch are OFF.

Step 3

Attach the housing attachment base.

Step 4

Turn on the power of the camera. ( page 13)

• Look inside the camera from the dome cover side

and confirm that the power LED (green) and the SD

memory card error LED (red) are blinking. When

they are blinking, the initialization is completed.

* When looking inside the camera from the part indi-

cated by the arrow mark in the illustration, the LEDs

can be found as shown in the illustration "View from

below".

REAR

Protection sheet

Step 5

Turn off the power of the camera, and then detach the

housing attachment base.

Step 6

Set DIP switch 1 to "OFF".

• Put the protection sheet back into place as it was

after setting DIP switch 1 to "OFF".

Important:

When DIP switch 1 is in the "ON" position, the cam-

era will not be operated in normal state. Make sure

that DIP switch 1 is in the "OFF" position.

Step 7

Attach the housing attachment base.

Step 8

Turn on the power of the camera. ( page 13)

• When the power of the camera is turned on, the

camera will be operated in normal state.

Green

Red