Panasonic WVNW964 - NETWORK CAMERA 설치 매뉴얼 - 페이지 24
{카테고리_이름} Panasonic WVNW964 - NETWORK CAMERA에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Panasonic WVNW964 - NETWORK CAMERA 32 페이지. Ip video cameras
Panasonic WVNW964 - NETWORK CAMERA에 대해서도 마찬가지입니다: 사용 설명서 (21 페이지), 서비스 매뉴얼 (28 페이지), 브로셔 (2 페이지), 참조 (2 페이지), 참조 (2 페이지), 사양 (2 페이지), 통합 참고 사항 (8 페이지)
페이지 인쇄
Initialize the camera
Use the DIP switch to initialize the camera.
Important:
The settings including the network settings will be initialized. Note that the preset position settings will not be ini-
tialized.
Step 1
Detach the housing attachment base, and then flip the
protection sheet on the upper portion of the sun shield.
• Refer to the operating instructions of the housing
attachment base for how to detach the sun shield.
Upper portion of the sun shield
DIP switch
Step 2
Set DIP switch 1 to "ON".
• The default positions of each DIP switch are OFF.
Step 3
Attach the housing attachment base.
Step 4
Turn on the power of the camera. ( page 13)
• Look inside the camera from the dome cover side
and confirm that the power LED (green) and the SD
memory card error LED (red) are blinking. When
they are blinking, the initialization is completed.
* When looking inside the camera from the part indi-
cated by the arrow mark in the illustration, the LEDs
can be found as shown in the illustration "View from
below".
24
REAR
Protection sheet
ON
1
2
Step 5
Turn off the power of the camera, and then detach the
housing attachment base.
Step 6
Set DIP switch 1 to "OFF".
• Put the protection sheet back into place as it was
after setting DIP switch 1 to "OFF".
Important:
When DIP switch 1 is in the "ON" position, the cam-
era will not be operated in normal state. Make sure
that DIP switch 1 is in the "OFF" position.
Step 7
Attach the housing attachment base.
Step 8
Turn on the power of the camera. ( page 13)
• When the power of the camera is turned on, the
camera will be operated in normal state.
<View from below>
Green
Red
ON
1
2