HP ProCurve 1600M Manual de instalação - Página 9

1. Download Switch Software

Your HP ProCurve Switch 2424M must be running OS version C.06.06 or later

to support the Gigabit Stacking Module. To determine which OS version is

running in the switch, connect a console to the switch and perform the

following (see the switch Installation Guide for more information about

connecting a console and using the console interface):

1. From the console Main Menu, press [1] to select Status and Counters... to

display the Status and Counters menu.

2. Press [1] again to select General System Information ... to display the Switch

Information screen, as shown in the next figure.

3. Check the "Firmware revision" line.

• If the revision number is C.06.06 or later, the switch can support the

Gigabit Stacking Module, and you do not need to download new soft-

ware to the switch. In this case, go to "Installing Transceivers in the

Module" on page 6.

• If the revision number is earlier than C.06.06, download the new soft-

ware before installing the Gigabit Stacking Module. In this case,

continue with the instructions in this section before you install the

module.

OS Version information

Installing the Module