Cisco WAP571E Manual de início rápido - Página 3

Procurar online ou descarregar pdf Manual de início rápido para Ponto de acesso sem fios Cisco WAP571E. Cisco WAP571E 6 páginas. Manually connect access points to the network via power over ethernet (poe)
Também para Cisco WAP571E: Manual de início rápido (17 páginas), Manual (4 páginas)

Imprimir página

Step 4. Slide the Ethernet cable through Part A of the weather-proof connector.

Step 5. Insert the thin red gasket into the opening of Part B of the weather-proof connector.

Connect the WAP571E via PoE

Important: Make sure that the network you are connecting the WAP to has PoE (802.3af and

802.3at) and that your network is up and running.

Step 1. Go over the back and bottom panels of the WAP571E.

Step 2. Position the WAP571E in such a way that the label underneath the device is right side up.

Step 3. Remove the cover of the port labeled ETH0/PD to expose the Ethernet port. This can be

done by turning the cap counter-clockwise.

Note: Take care not to lose the thin rubber gasket.

Step 4. Connect the Ethernet cable into the ETH0/PD slot of the WAP571E.