Cisco WAP571E Hızlı Başlangıç Kılavuzu - Sayfa 3

Kablosuz Erişim Noktası Cisco WAP571E için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Cisco WAP571E 6 sayfaları. Manually connect access points to the network via power over ethernet (poe)
Ayrıca Cisco WAP571E için: Hızlı Başlangıç Kılavuzu (17 sayfalar), Manuel (4 sayfalar)

Sayfayı Yazdır

Step 4. Slide the Ethernet cable through Part A of the weather-proof connector.

Step 5. Insert the thin red gasket into the opening of Part B of the weather-proof connector.

Connect the WAP571E via PoE

Important: Make sure that the network you are connecting the WAP to has PoE (802.3af and

802.3at) and that your network is up and running.

Step 1. Go over the back and bottom panels of the WAP571E.

Step 2. Position the WAP571E in such a way that the label underneath the device is right side up.

Step 3. Remove the cover of the port labeled ETH0/PD to expose the Ethernet port. This can be

done by turning the cap counter-clockwise.

Note: Take care not to lose the thin rubber gasket.

Step 4. Connect the Ethernet cable into the ETH0/PD slot of the WAP571E.