Cisco WAP571E 빠른 시작 매뉴얼 - 페이지 3

{카테고리_이름} Cisco WAP571E에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco WAP571E 6 페이지. Manually connect access points to the network via power over ethernet (poe)
Cisco WAP571E에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (17 페이지), 매뉴얼 (4 페이지)

페이지 인쇄
Cisco WAP571E 빠른 시작 매뉴얼
Step 4. Slide the Ethernet cable through Part A of the weather-proof connector.
Step 5. Insert the thin red gasket into the opening of Part B of the weather-proof connector.
Connect the WAP571E via PoE
Important: Make sure that the network you are connecting the WAP to has PoE (802.3af and
802.3at) and that your network is up and running.
Step 1. Go over the back and bottom panels of the WAP571E.
Step 2. Position the WAP571E in such a way that the label underneath the device is right side up.
Step 3. Remove the cover of the port labeled ETH0/PD to expose the Ethernet port. This can be
done by turning the cap counter-clockwise.
Note: Take care not to lose the thin rubber gasket.
Step 4. Connect the Ethernet cable into the ETH0/PD slot of the WAP571E.