Argo AWICS19 Manual de instruções de instalação - Página 14

Procurar online ou descarregar pdf Manual de instruções de instalação para Ar condicionado Argo AWICS19. Argo AWICS19 18 páginas. Split air conditioner system

Imprimir página

14 - MATCH BETWEEN REMOTE CONTROLLER AND INDOOR UNIT

(TRANSMISSION CHANNEL)

The remote control can be addressed to use up to 4 different units installed in the same room.

You can get unified control by using a single remote control for all units or each remote control can be addressed to its

own unit, in order to control separately temperature, timer and all other functions.

PCB SETTING

• Disconnect the unit power supply and wait at least 60 seconds, making sure that all the lamps go off.

• Remove the front panel to access the pcb.

• Set SW3 as shown in the table.

• Close the front panel.

• Reconnect the unit power supply.

REMOTE CONTROLLER SETTING

• Press the button

• Press the arrow

• Press the button

number 0 (factory setting) at the bottom starts flashing.

• Press the arrow

• Confirm with the button

• Press

to exit the menu.

CHANNEL

FACTORY STATE

for a few seconds.

until you visualize 06.

again for a few seconds: the

to set 0, 1, 2 or 3.

REMOTE CONTROL UNIT

WIRED CONTROLLER SETTING

• Press the MENU / PARAMETERS button for 2 seconds.

• Use the  /  buttons until 6 is displayed.

• Press the OK button for 2 seconds: now it is possible

to change the value of the parameter using the  / 

buttons.

• Set 0, 1, 2 o 3.

•

Press OK to confirm

SW3: 1=OFF 2=OFF

SW3: 1=ON 2=OFF

SW3: 1=OFF 2=ON

SW3: 1=ON 2=ON

UNIT PCB