CablesPlus SCM-1 Manual de início rápido - Página 2

Procurar online ou descarregar pdf Manual de início rápido para Racks & Stands CablesPlus SCM-1. CablesPlus SCM-1 4 páginas.

Imprimir página

Step 2: Attaching the carriage to

the ceiling plate

Step 3: Attaching the near

ﬂ ush pipe or 1.5" NPT pipe to

the carriage

Step 4: Attaching the female pipe

couple to the mount

Step 1

Before starting, lay out all parts to your mount and match them to the

parts list provided. Verify that you have all your parts before attempt-

ing to assemble the mount.

Step 2

Lay the ceiling plate

ing plate rest on top of the ceiling runners. Tighten adjustable screws

to hold the plate in place. Slide the carriage

position and use the ¼" – 20UNC screws

to secure the carriage

Step 3

The next steps are for those who are going to use either the near

ﬂ ush pipe

or 1.5" NPT pipe for installation of the mount. Those

who wish to use the mast provided with the mount proceed to step

7. Mark and cut a 2.25" hole where you desire the near ﬂ ush pipe

or 1.5" NPT pipe to come down. Insert the near ﬂ ush pipe or

1.5" NPT pipe through the ceiling tile and into the carriage

a brake screw

in the bottom threaded hole of the carriage to

secure the near ﬂ ush pipe or 1.5" NPT pipe.

Step 4

Attach the desired mount to the female pipe couple

. For the LCD-2537C, PM-1, PM-2, PM-3, or PM-3B this is done

with parts

instructions is the PM-1. For the LCD-1C, LCD-1C w/ LCD-CM2, VMP-

042/044, or VMP046/048 this is done with parts

The plastic washer

goes on top of the desired mount as well as

inside the bottom of the female pipe couple

VIDEO MOUNT PRODUCTS

onto the ceiling grid so the lips of the ceil-

, washers

in place.

, and

. Note: The mount shown in the

into the desired

, and nuts

. Use

, and

. Note: