CablesPlus SCM-1 Manual de início rápido - Página 4

Procurar online ou descarregar pdf Manual de início rápido para Racks & Stands CablesPlus SCM-1. CablesPlus SCM-1 4 páginas.

Imprimir página

Step 8: Attach the adaptor plate

to the carriage

Step 9: Supporting the ceiling

plate with tie wire

Step 10: Attaching the lower half of

the mount to the upper mast

VIDEO MOUNT PRODUCTS

Step 8

Place the escutcheon ring adaptor

trace around the outside of the adaptor. Then proceed to cut just

inside the circle drawn. Insert the adaptor into the hole making sure

you have a tight ﬁ t, and the wider top is on top of the ceiling tile. If

necessary widen the hole slightly to ﬁ t in the adaptor. Insert the top

of the ceiling mast through the hole in the ceiling tile. Attach the

adaptor plate

to the carriage

screw

to secure the adaptor plate

Step 9

Insert the turnbuckles

into the ceiling plate

the sets of four holes in each corner of the ceiling plate and not the

center hole on each side. If necessary use the wood screw eyebolt

or concrete anchor

use the tie wire cut the provided wire

Then insert one piece through each turnbuckle and twist the wire at

least four times itself. Attach the other end of each piece of wire to

the eyebolts, concrete anchors, or ceiling truss again making sure

the wire is twisted around itself at least four times. The ceiling plate

should be completely supported by the tie wires. Note: If the dis-

tance between the ceiling grid and wherever you're attaching the

tie wires is longer than 3 feet then you will require more tie wire (12

gauge steel tie wire).

Step 10

Attach the lower mast and rest of the mount to the upper mast us-

ing the appropriate through bolt and nut for that mount. Attach

the escutcheon ring

onto the escutcheon ring adaptor

Please verify that all nuts and screws are securely tightened.

Enjoy Your Mount!

WARNING: The installer of these products must verify that the mount-

ing surface, ceiling or wall, will safely support the combined weight

of all attached equipment and hardware. Video Mount Products will

not be held liable for the improper use or installation of its products.

on top of the ceiling tile and

and use the ¼" – 20UNC brake

from turning.

. Make sure to use

to provide tie wire anchor points. To

into four equal pieces.