CablesPlus SCM-1 Manual de início rápido - Página 3

Procurar online ou descarregar pdf Manual de início rápido para Racks & Stands CablesPlus SCM-1. CablesPlus SCM-1 4 páginas.

Step 5

Insert the turnbuckles

into the ceiling plate

. Make sure to use

the sets of four holes in each corner of the ceiling plate and not the

center hole on each side. If necessary use the wood screw eyebolt

or concrete anchor

to provide tie wire anchor points. To

use the tie wire cut the provided wire

into four equal pieces.

Then insert one piece through each turnbuckle and twist the wire at

least four times itself. Attach the other end of each piece of wire to

the eyebolts, concrete anchors, or ceiling truss again making sure

the wire is twisted around itself at least four times. Note: If the dis-

tance between the ceiling grid and wherever you're attaching the

Step 5: Supporting the ceiling plate

tie wires is longer than 3 feet then you will require more tie wire (12

with tie wire

gauge steel tie wire).

Step 6

Attach the escutcheon ring

to the near ﬂ ush pipe

or 1.5"

NPT pipe. Attach the female pipe couple

, and

to the

near ﬂ ush pipe or 1.5" NPT pipe. Use the ¼" – 20UNC brake screw

to secure the top of the couple

from turning on the near

ﬂ ush pipe or 1.5" NPT pipe.

Please verify that all nuts and screws are tight.

Step 7

Attach the top of the ceiling mast (usually called the ceiling plate

in the instructions) to the adaptor plate

. For the masts with a

cable channel make sure to nest the cable channel in the depres-

Step 6: Attaching the female

sion cut out in the adaptor plate. Secure the two together with 3/8"

pipe couple to the near ﬂ ush

– 16UNC screw

, washers

, and hex nuts

pipe or 1.5" NPT pipe

Step 7: Attaching the upper mast

to the adaptor plate