Cisco 2600 Series Manual de instalação - Página 7

Procurar online ou descarregar pdf Manual de instalação para Porta de entrada Cisco 2600 Series. Cisco 2600 Series 12 páginas. Configuring adsl wic to support pppoe clients
Também para Cisco 2600 Series: Notas de lançamento (32 páginas), Configuração (15 páginas), Nota de aplicação (41 páginas), Ficha de dados (6 páginas), Apêndice (15 páginas), Manual de instalação (22 páginas), Visão geral (13 páginas), Manual de início rápido (2 páginas), Manual (5 páginas)

Removing the Power Supply

This section describes how to remove the internal power supply. Although the AC power supply is

shown in the illustrations that follow, the procedure is the same for removing both the AC and DC

power supplies.

Take these steps to remove the power supply:

Step 1

Figure 4

Step 2

Figure 5

Screw

Locate the six-pin connector on the system board near the front of the router, and

disconnect it. (See Figure 4.)

If cable tie-wraps on the harness interfere with removing the connectors, cut the

Note

tie-wraps, being careful not to cut the power supply wires.

Locating the Connectors

Fan

Power connector

Fan connector

Remove the mounting screw that secures the power supply to the chassis. (See Figure 5.)

Set aside this screw for later use.

Removing the Mounting Screw

Installing the Cisco RPS Adapter Plate in Cisco 2600 Series Routers

Removing the Power Supply

AC power supply