Cisco 2600 Series Руководство по установке - Страница 7

Просмотреть онлайн или скачать pdf Руководство по установке для Шлюз Cisco 2600 Series. Cisco 2600 Series 12 страниц. Configuring adsl wic to support pppoe clients
Также для Cisco 2600 Series: Информация о выпуске (32 страниц), Конфигурация (15 страниц), Примечание по применению (41 страниц), Информационный лист (6 страниц), Приложение (15 страниц), Руководство по установке (22 страниц), Обзор (13 страниц), Краткое руководство по эксплуатации (2 страниц), Руководство (5 страниц)

Removing the Power Supply

This section describes how to remove the internal power supply. Although the AC power supply is

shown in the illustrations that follow, the procedure is the same for removing both the AC and DC

power supplies.

Take these steps to remove the power supply:

Step 1

Figure 4

Step 2

Figure 5

Screw

Locate the six-pin connector on the system board near the front of the router, and

disconnect it. (See Figure 4.)

If cable tie-wraps on the harness interfere with removing the connectors, cut the

Note

tie-wraps, being careful not to cut the power supply wires.

Locating the Connectors

Fan

Power connector

Fan connector

Remove the mounting screw that secures the power supply to the chassis. (See Figure 5.)

Set aside this screw for later use.

Removing the Mounting Screw

Installing the Cisco RPS Adapter Plate in Cisco 2600 Series Routers

Removing the Power Supply

AC power supply