Whirlpool 27' Manual de instruções de instalação - Página 10

Procurar online ou descarregar pdf Manual de instruções de instalação para Secador Whirlpool 27'. Whirlpool 27' 27 páginas. Microwave oven and thermal oven
Também para Whirlpool 27': Ajuda de trabalho (36 páginas), Manual de instruções de instalação (11 páginas), Manual de instruções de instalação (11 páginas), Manual de instruções de instalação (48 páginas), Manual de instruções de instalação (22 páginas), Manual de instruções de instalação (32 páginas), Manual de instruções de instalação (12 páginas), Instruções de instalação (5 páginas)

Imprimir página
Whirlpool 27' Manual de instruções de instalação

REMOVE SHIPPING STRAP

To avoid floor damage, set washer/dryer onto cardboard before
moving across floor. Move washer/dryer close to its final location.
1.
Remove strap, hang tag, and pin
Do not cut yellow strap. Pull yellow strap firmly, until completely
removed from washer/dryer. There should be 2 cotter pins on
the end of the shipping strap. Remove the hang tag and pin
from the vent pipe.
2.
Check rear leveling legs
Tilt the washer/dryer forward. Move each of the 2 rear legs in
an up-down motion to check the self-adjusting leveling legs
for free movement. This is required for proper leveling. Gently
lower the washer/dryer to the floor.
3.
Cut shipping strap
Cut the shipping strap about 16" (406 mm) from the plug end.
Look for the words "CUT HERE." Discard end with cotter pins.
You will use the remaining piece of shipping strap to secure
the drain hose.
10

INSTALL LEVELING LEGS

1.
Prepare to install leveling feet
Prop up the front of the washer/dryer
about 4" (102 mm) with a wood block
or similar object that will support the
weight of the washer/dryer. Then screw the locknut onto each
foot to within 1" (25 mm) of the foot base.
2.
Install front leveling feet
Screw the feet into the threaded holes at
the front corners of the washer/dryer until
the jam nuts touch the washer.
NOTE: Do not tighten the nuts until the washer/dryer is level.
Tilt the washer/dryer back and remove the wood block. Gently
lower the washer/dryer to the floor.
1"
(25 mm)