Whirlpool 27' Інструкція з монтажу Посібник з монтажу - Сторінка 10

REMOVE SHIPPING STRAP

To avoid floor damage, set washer/dryer onto cardboard before

moving across floor. Move washer/dryer close to its final location.

Remove strap, hang tag, and pin

Do not cut yellow strap. Pull yellow strap firmly, until completely

removed from washer/dryer. There should be 2 cotter pins on

the end of the shipping strap. Remove the hang tag and pin

from the vent pipe.

Check rear leveling legs

Tilt the washer/dryer forward. Move each of the 2 rear legs in

an up-down motion to check the self-adjusting leveling legs

for free movement. This is required for proper leveling. Gently

lower the washer/dryer to the floor.

Cut shipping strap

Cut the shipping strap about 16" (406 mm) from the plug end.

Look for the words "CUT HERE." Discard end with cotter pins.

You will use the remaining piece of shipping strap to secure

the drain hose.

Prepare to install leveling feet

Prop up the front of the washer/dryer

about 4" (102 mm) with a wood block

or similar object that will support the

weight of the washer/dryer. Then screw the locknut onto each

foot to within 1" (25 mm) of the foot base.

Install front leveling feet

Screw the feet into the threaded holes at

the front corners of the washer/dryer until

the jam nuts touch the washer.

NOTE: Do not tighten the nuts until the washer/dryer is level.

Tilt the washer/dryer back and remove the wood block. Gently

lower the washer/dryer to the floor.

(25 mm)