AER COMPACT 60 2 Manual do utilizador - Página 7

Procurar online ou descarregar pdf Manual do utilizador para Amplificador de instrumentos musicais AER COMPACT 60 2. AER COMPACT 60 2 10 páginas. Amplifier
Também para AER COMPACT 60 2: Manual de instruções (8 páginas)

Imprimir página

5.2 Effects

The Compact 60

has a built-in (internal) digital ef-

fect processor, with the select-switch you can choose

between 4 different effects:

1 = reverb 1 (short)

2 = reverb 2 (long)

3 = delay (320 ms)

4 = chorus

The efx-level-control determines the intensity of the

internal effects (left stop = no effect).

Furthermore an additional effects unit (external ef-

fect) may be connected to the Compact 60

purpose use the send and return sockets on the rear

side of the amplifier (send goes to input, return to

the output of the external effects device). The inten-

sity of the effect is adjusted at the external effects

unit.

With the efx-pan control the different effects are

blended with the original signal. The efx-pan works

as follows:

left stop:

internal effect on channel 1

external effect on channel 2

mid position:

internal effects on channel 1 + 2

external effects on channel 1 + 2

right stop:

internal effects on channel 2

external effects on channel 1

5.3 Footswitch

A standard double-footswitch (on-/off-switch) can be

plugged into the footswitch-socket on the rear side

of the amplifier via stereo cable. By this footswitch

the internal and external effects can be switched on

and off.

5.4 Phantom power

Microphones requiring 48V phantom power can be

connected to the XLR-socket of channel 2 directly.

Factory-provided phantom power is activated but, if

required, may be deactivated by an internal jumper.

In contrary 9V phantom power, if required, can ad-

ditionally be activated in channel 1 by an internal

jumper.

Please note: For both alterations the device must be

opened, therefore only qualified service personnel

may carry out the modifications concerning the de-/

. For this

activating of phantom power.

General Note: Use of 48V or 24V phantom po-

wer

(Phantom power = remote supply, here: powering

an audio device via the connected audio line)

Turn on the phantom power only if the unit connec-

ted to an XLR socket that is designed to handle it!

In general, suitable units are e.g. condenser micro-

phones, active DI-boxes and other special audio

devices, whose power supply is drawn from the

phantom power. Such devices are also labelled ac-

cordingly; please heed the permissible power con-

sumption (max.10mA).

High-quality dynamic microphones with a balanced

signal need no phantom power, but can handle it

anyway.

Other devices, which have not been designed expli-

citly for phantom power operation, can suffer from

considerable malfunctions and damage may result as

well.

Examples of devices that may be damaged by incor-

rect application of phantom power include:

Low-cost dynamic microphones with a mono jack-

plug (unbalanced signal) that were fitted afterwards

with an XLR connector.

Audio devices with a balanced XLR output (e.g. DI-

boxes, effects devices, instrument preamps with a DI

output etc.) which are not protected against phan-

tom power applied to their XLR output. (The DI con-

nectors on AER products are protected against ap-

plied phantom power.)

Other audio devices (such as preamps, effects pedals

etc.) whose unbalanced line output was replaced by

an XLR socket.

If in doubt please consult the manufacturer of the

device you are using.