Clarke STRONG-ARM CSA12F Manual de Instruções de Operação e Manutenção - Página 3
Procurar online ou descarregar pdf Manual de Instruções de Operação e Manutenção para Ferramenta eléctrica Clarke STRONG-ARM CSA12F. Clarke STRONG-ARM CSA12F 17 páginas. 12 tonne hydraulic press
Também para Clarke STRONG-ARM CSA12F: Manual de Instruções de Operação e Manutenção (17 páginas)
Imprimir página
SAFETY PRECAUTIONS
• The components of this press are specially designed to withstand the rated
capacity. Do not substitute bolts, pins, or any other components.
• During assembly or if the press is moved, always call for the help of an
assistant, do not manhandle single-handedly.
• Ensure the press is bolted down onto a solid, flat surface.
• Ensure the press is located on firm level ground with adequate light.
• Before applying a load, ensure all press bed support pins are fully engaged.
• Ensure that hydraulic hoses and couplings are completely sound.
• Before use, always ensure the workpiece is firmly secure and stable.
• Always clean spills of hydraulic oil immediately as this can be dangerous in a
workshop environment.
• Do not exceed the rated capacity of the press.
• Do not allow any person who is inexperienced in the use of hydraulic presses,
to use the press unless they are under direct supervision.
• Do not work directly in front of the press when it is in use.
• Never tamper with the press. The safety valve is calibrated and sealed at the
factory; do not attempt to change the setting.
• Use only the recommended hydraulic oil.
• Always apply the load under the centre of the ram. Offset loads can
damage the ram or ram mount and may cause the work piece to eject.
• Before use, check for signs of cracked welds, bent bed pins, loose or missing
bolts, or any other structural damage. Do not operate if any of these are
found. Have repairs made only by authorised service centre.
• Remove any load from press bed before attempting to adjust bed height.
• Press only on a work piece supported by the press bed.
• When using accessories such as pressing plates, be certain they are
centered below the ram and are in full contact with the bed.
• Parts being pressed may splinter or be ejected from the press. Due to varied
applications, it is your responsibility to always use adequate guards, wear
eye protection and protective clothing when operating this press.
• Keep hands and fingers away from parts that may pinch and shift.
• Do not use extension tubes on the pump handle. Excessive effort can cause
damage and/or accidents.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
3