Alumax ProLine PL70 Manual de instruções de instalação - Página 4

Procurar online ou descarregar pdf Manual de instruções de instalação para Invólucro Alumax ProLine PL70. Alumax ProLine PL70 8 páginas. Heavy frameless bypass bath enclosure

Imprimir página

Notes:

This is a two person installation.

All marks made on tile, marble or fiberglass should be made lightly in

pencil so they can be removed after the installation is complete. An

optional method is to use masking tape on the walls and sill that can be

removed as the installation progresses.

Establish Centerlines – The centerlines of the unit must be

established on the shower sill and on the walls as well. Measure

the width of the shower sill and mark the centerline down the middle.

Transfer the centerline to the walls using a level. Mark Header Bar

location at 3 1/4" less than the unit height, on the centerline. Measure,

and write down, the distance between the two Wall Mount marks.

Bar Mount – Drill the Wall Mount holes 5/16" diameter. Insert the

Wall Anchors [A] fully into the holes. Using the 1/4 x 2" Flat head

screws [C] attach the Wall Mount Blocks [B] to the wall, with the long

edge vertical.

Bar Length - Measure the width of the fixed glass panel [F].

Subtract 2" from that dimension. Measure from the center of the

middle hole in the bar to the fixed panel end of the bar and cut that

end off (The fixed panel end is the one with the second hole in it). Now

subtract 1" from the measurement taken in step 1. Measure from the

cut end of the bar to the uncut end and cut that end off of the bar.

Page 5 of 9