Alumax ProLine PL70 Manual de instruções de instalação - Página 5

Procurar online ou descarregar pdf Manual de instruções de instalação para Invólucro Alumax ProLine PL70. Alumax ProLine PL70 8 páginas. Heavy frameless bypass bath enclosure

Imprimir página

Glass Clips and Threshold – Mark the center point of the

sill, along the centerline, established in step one. Make

a mark 1/2" over toward the Fixed Panel [E] side and 11/16"

outside of the centerline. Make another mark 2" over from the

wall and 11/16" outside of the centerline. Drill a 1/4" hole at

each of these marks. Clean the area around the holes and

put a little silicone into each hole. Press the Clip Anchors [F]

into the hole until fully seated. Measure the sill width at the

centerline, and cut the Threshold [G] to that dimension. Place

the Threshold on the sill next to the Clip holes. Transfer the

Glass Clip [H] hole locations on the sill over to the Threshold.

Notch or drill a 3/8" hole in the Threshold, for the Glass

Clip Screws [ I ] to pass through. You can also cut about a

3/8" section out of the threshold at each location. Place the

Threshold on the sill and place the Glass Clips over it, at the

correct locations. Align the Threshold so that it is straight.

Tape it down in a few spots and lightly trace the inside edge.

Remove the tape, Threshold and Glass Clips. Run a bead of

caulk, approximately 1/8" outside of the mark you just made.

Replace the Threshold and fasten the Glass Clips to the sill

with the clip screws. Install the Vinyl Inserts [J] into the Glass

Clips. CAUTION: Tape the threshold down to keep it from

being moved during the rest of the installation

Center Guide – At the middle of the centerline, make a

mark approximately 2" long and 13/16" to the inside of

the enclosure. Place the Center Guide [K] on the new mark,

centered on the middle of the centerline. Mark the center of

the attachment holes and, remove the Center Guide. Drill two

5/16" holes at the marked locations. Clean the area around

the holes and put a little silicone into each hole. Press the

Center Guide Anchors [L] into the holes until the lip is flush

with the sill. IMPORTANT: Make sure that the lobe on the

Center Guide Insert [M] is engaged with the proper slot in the

Center Guide, as shown. Mount the Center Guide with the

Center Guide Screws [N].

Page 6 of 9